By Mick on Monday, 22 November 2010
Category: VDubber

Somewhere to put stuff

Managed to get a spare 5 minutes this weekend to get out in the garage and finish off assembling the shelving that I bought. The shelves are similar to the ones you see in warehouses that are used to hold pallets, except, they are a little smaller. Each upright section is about 2 metres tall, and the self spans are 1800mm wide. The shelves themselves are 600mm wide, 15mm thick MDF, plenty big enough to fit lots of stuff. I bought 3 sections, which takes up a little over half of the length of the garage. Might add another section on, but not too sure yet, will see how I go.

So far I've managed to fill a couple up with the parts from the Ghia and the Oval, but still have plenty of room left.

My current aim is to move all of the stuff from the old work bench in the existing garage, on to the new shelves. Then I can dismantle the bench, and finish knocking the back wall out, which will allow me to move the splitty into the rear part of the garage, followed by the Jag, and the oval.

Need to get this done in the next couple of weeks as we've got a new swing arriving for Locke's xmas prezzie, this is due to go where the Oval currently sits, so need to get it moved out of the way, plus it will be nice to clear the garden out of old bits of car, not to mention that I'm dead keen to see the garage kitted out too.

Still got some other stuff to get done too, but slowly getting there.

Leave Comments