• Took a look at the drop spindle conversion yesterday. The idea is to fit late bay drop spindles and then make some adaptors to convert to wide 5. This way I get both drop spindles and discs.

    I previously had some adaptor plates cut from 10mm steel but on fitting noted that the centres are way bigger then the hubs that I have (the hubs are brand new Empi versions) I'm guessing that the original hubs are a different diameter. At any rate I will need to get some more adaptors made up. This time I will just get some blanks cut and then finish them off myself. The laser cutting was not great, it looks like they had the machine too fast as there was a lot of deflection in the cut. Not great when you need it to be accurate.

    I will machine the new ones in my lathe and then drill the holes using my dividing head - this way I can ensure concentricity and make sure that the plate is a snug fit on the hub - this ensures that the load is transferred to the hub and is not taken up by the wheel studs. The countersunk bolts stop it from looking too much like a bolt on wheel adaptor.
    0
    0
    0
    0
    0
    0
    Comments (0)
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
Monthly Leaders
Featured Build-Page
Latest Blog Posts